Directed Electronics AutoCommand 28623TN Owner's Installation Manual page 20

If the GREEN wire is being used for ign2 an additional relay (not
provided) is required for a 2nd accessory.
Now that the accessories have been located, find the suspected
starter wire according to the web information. Leave the black
lead of your tester on ground and place the red lead of your multi-
meter on this wire. The multimeter should read 0 volts in all key
positions except the crank position. In the crank position your
multimeter should read 12 volts, and will go to 0 volts when the
starter disengages.
Many Nissan and late-model Chrysler vehicles have two starter
wires. A relay and/or resistor (not provided) is required to hook up
the additional starter wire. Refer to the diagram below.
YELLOW (+) OUTPUT
TO STARTER
note! Always check the Web site information
on your vehicle for warnings regarding the
starter wire and check engine lights. Some
vehicles will trip a check engine light if the
starter wire is cut.
© 2006 Directed Electronics
+12 VDC CONSTANT (FUSED 20A)
TO STARTER
+12 VDC CONSTANT (FUSED 20A)
STARTER RELAY
(NOT PROVIDED)
87
GROUND
86 85
87A
30
TO STARTER
2 nd STARTER RELAY
(NOT PROVIDED)
87
GROUND
86 87A 85
30
TO 2 nd STARTER
17