Canon LBP-1000 Service Manual page 173

IV. MESSAGES TABLE
Message
READY The printer is ready to receive data and
print.
PAUSED The printer is off-line.
RESET TO SAVE RESET verification prompt.
This message appears momentarily and then
PAUSED. When a menu item was changed
before the printer releases the port on which
the last job was processed, such as in the
middle of a job, or before the port timed out.
MEMORY OVER- A memory overflow has occurred.
FLOW The printer received more data than it can
hold in the available memory on the printer.
This can occur if too many soft fonts,
macros, or complex graphics are sent to the
printer.
PRINTING... Usually displayed when printing an item
from the TEST MENU, or when attempting to
go off-line while the printer is busy.
+ FORMAT FLASH The FORMAT FLASH item is selected to for-
- IGNORE FLASH mat the optional Flash ROM.
+ REALLY FORMAT The operator is being asked to verify the
- IGNORE FLASH Flash ROM formatting is really wanted. This
is in response to the foregoing message.
FLASH OVERFLOW A memory overflow has occurred in the
optional Flash ROM
The printer has received more font and
macro data than it can hold in the available
memory of the Flash ROM. The printer goes
off-line when this message is displayed.
Meaning
APPENDEX
Action
No action required.
Press Go key.
Two options are available:
1. Press Shift+Enter key to enter
the RESET menu and save the
information immediately.
will terminate the current job,
deleting temporary fonts, macros
and buffered data.
2. Press Go key and the current
job will resume where it left off.
The menu items changed will not
take effect until the next end of
job.
The job will resume after 10 sec-
onds if AUTOCONT
Otherwise press the Go key to
resume printing. Check the page
that ejects since the page could
not be processed as requested.
Also simplify the job or add addi-
tional memory.
No action required.
Select + (press Value key) to for-
mat the Flash ROM. Select -
(press Shift and Value keys) to
cancel the operation.
For new/unformatted
ROM: the printer will automati-
cally format the Flash ROM with-
out any message display when
the printer is warming up.
Select + (press Value key) to veri-
fy that the Flash ROM is to be
formatted. Select - (press Shift
and Value keys) to cancel the
operation.
Press the Go key to take the
printer back on-line.
Format the Flash ROM or delete
font and macro data to create
more space.
This
is ON.
Flash
A - 11