CHAPTER 3
5. Removal of the paper sensor
1) Remove the cassette.
2) Place the paper feeder upside down.
3) Unhook the claw, and then remove the
cover.
4) Disconnect the connector, unhook the 2
claws, and then remove the paper sen-
sor.
3 - 32
6. Removal of the paper feeder PCB
1) Remove the cassette.
2) Place the paper feeder upside down.
3) Unhook the 4 claws, and then remove
the cover.
Claws
Cover
Figure 3-9-8
4) Disconnect the 3 connectors, remove
the 2 screws, and then the paper feeder
PCB.
Connectors
Screws
Paper feeder PCB
Figure 3-9-9