Canon LBP-1000 Service Manual page 101

CHAPTER 3
H. Transfer Charging Roller
1) Open the top cover.
2) Unhook the claw of the left bushing of
the transfer charging roller. Lifting the
roller slightly, remove the right side of
the shaft from the bushing.
the transfer charging roller.
Bushings
Transfer charging roller
Figure 3-4-10
< Notes for reassembly >
When installing the roller, hold the shaft
and bushing, not the sponge area, of the
transfer charging roller.
When the roller is set, insert the spring
into the boss of the bushing securely so
that the bushing pushes the spring.
Bushing
Figure 3-4-11
3 - 14
I. Fixing Film Unit
1) Remove the fixing unit according to the
steps 1) through 3) on page 3-9.
2) Disconnect the connector from the
delivery sensor.
Remove 3) Remove the cables from the guides.
Connector
4) Remove the 2 screws.
5) Unhook the 2 claws, and then remove
the cover.
Shaft
Screws
Cover
Note:
Cables
Figure 3-4-12
Claws
Figure 3-4-13
In the procedure 5), use care when
unhooking the 2 claws. The cover
springs up due to the spring ten-
sion.