Coded Speed Dialing List; List Of Documents In Memory - Canon FAX-JX300 User Manual

One-Touch Speed Dialing List
Lists the numbers and names registered under one-touch speed dialing buttons.

Coded Speed Dialing List

Lists the numbers and names registered under coded speed dialing codes.
User's Data List
Lists the current settings of the fax and the registered sender information.

List of Documents in Memory

Lists the documents currently stored in the fax's memory (see page 35).
TX (Transmission) Report
Normally the fax does not print an activity report for transmitting, but you can set the fax to print
an activity report every time you send a document. See <TX REPORT> on page 49.
You can set the fax to print an activity report only when an error occurs during transmitting. See
<TX REPORT> on page 49.
RX (Reception) Report
Normally the fax does not print an activity report for receiving, but you can set the fax to print an
activity report every time you receive a document. See <RX REPORT> on page 49.
You can set the fax to print an activity report only when an error occurs during receiving. See
<RX REPORT> on page 49.
Multi TX (Transmission) Report
Lists the result of a sequential broadcasting.
If you set the fax to print a <TX REPORT> and then use sequential broadcasting, a MULTI TX
REPORT will be printed instead of a TX (Transmission) REPORT. See <TX REPORT> on
page 49.
Note
FAX-JX500/JX300 models:
Faxes or messages stored in the memory are backed up automatically if the power is tuned off or
fails. If however, the data cannot be retried when the power is tuned on again, a memory clear
report is printed automatically.
FAX-JX200/JX201 models:
A memory clear report is printed automatically when power is restored after a power failure. See
"Memory Clear Report" on page 73.
54 Settings and Activity Reports