Setting Tam Monitor; Setting Toll Saver - Canon FAX-JX300 User Manual

3
Use [{] or [}] to select <TAM SETTINGS>, then press [Start/Copy] twice. The
LCD displays <60 SECONDS>.
4
Use [{] or [}] to select the recording time, then press [Start/Copy].
The recording time can be set to 0, 60, 120 or 240 seconds.
5
Press [Stop].
Setting ends and the fax returns to standby mode.
Note
When the recording time is set to 0, the alternative outgoing message is played. If an alternative
outgoing message has not been recorded, the outgoing message is played. In this case, there will
be no beep after the message is played and the caller will not be able to leave a message.

Setting TAM MONITOR

<TAM MONITOR> allows you to screen all incoming calls.
Note
To use this feature, <LINE MONITOR VOL> (see page 49) must be set to a setting other than 0. If
<LINE MONITOR VOL> is set to 0, you will not be able to hear any incoming messages as they are
being recorded.
1
Press [Menu].
2
Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy]. The
LCD displays <USER SETTINGS>.
3
Use [{] or [}] to select <TAM SETTINGS>, then press [Start/Copy]. The LCD
displays <MESSAGE LENGTH>.
4
Use [{] or [}] to select <TAM MONITOR>, then press [Start/Copy]. The LCD
displays <ON>.
5
Use [{] or [}] to select <ON>, then press [Start/Copy].
6
Press [Stop].
Setting ends and the fax returns to standby mode.

Setting TOLL SAVER

Setting <TOLL SAVER> allows you to check whether you have any new messages when you
call from a remote location. When <TOLL SAVER> is set to <ON> and there are new messages,
the fax will answer after the second ring. If there are no new messages the fax will ring five times
before answering.
1
Press [Menu].
2
Use [{] or [}] to select <DATA REGSTRATION>, then press [Start/Copy]. The
LCD displays <USER SETTINGS>.
3
Use [{] or [}] to select <TAM SETTINGS>, then press [Start/Copy]. The LCD
displays <MESSAGE LENGTH>.
Using TAM Mode (FAX-JX500/JX300 only) 39