Canon FAX-JX300 User Manual page 45

Note
A password is required to use the remote control features. However, if <PIN ENTRY> is set to
<OFF> (see page 52), it is not necessary to enter your password when you use the
<FORWARDING MSG> feature (see page 45).
If you enter an invalid password, you will hear an error tone. If you enter two invalid passwords
consecutively, the call will be disconnected.
You should enter a remote command within 20 seconds of entering your password. If more than
20 seconds elapse after you enter your password and you do not enter a remote command, the
call will be disconnected.
The remote control features can be used even when the fax is set to a mode other than <TAM
MODE>.
In <FAX ONLY MODE>, the outgoing message will not be played. Press [#] when the call is
connected.
In Fax/Tel mode (FAX/TEL AUTO SW), press [#] while the Fax/Tel message is playing. If you
have not recorded a Fax/Tel message, press [#] when the call is connected.
When the fax is set to <MANUAL MODE> and <MAN/AUTO SWITCH> has been set to <OFF>
(see page 50), <TAM MODE> will be activated if the fax rings 15 times and the call is not
answered (only when an outgoing message has been recorded). When the call is disconnected,
the fax returns to <MANUAL MODE>. Press [#] while the outgoing message is playing. Then,
enter your password when you hear the beeps.
Using TAM Mode (FAX-JX500/JX300 only) 43