Sequential Broadcasting; Sending A Document To More Than One Location - Canon FAX-JX300 User Manual

Sequential Broadcasting

Sending a Document to More Than One Location

Sequential broadcasting sends one document to more than one location.
You can send to a total of 110 locations (70 locations for the FAX-JX200/JX201 models) as
follows:
One-touch speed dialing
Coded speed dialing
Regular dialing (Numeric buttons dialing)
You can enter the one-touch speed dialing and coded speed dialing locations in any order. You
simply press the one-touch speed dialing button, or press [Coded] or [Directory] followed by the two-
digit code.
You can also include one location using regular dialing. Remember that when using regular dialing,
you must press [Start/Copy] after entering the number.
Note
You must press each button within 10 seconds of the preceding one. The fax begins the operation
approximately 10 seconds after you press the last button.
The regular dialing number must be entered last.
1
Load the document face up into the Document Tray.
See "Loading Documents and Paper" on page 15.
You can set the scanning resolution and contrast (see page 19).
2
Dial the receiving party's fax numbers as you need.
You can also press [Redial] to redial the last number dialed with the numeric buttons.
TEL= 3456xxxx
3
Press [Start/Copy].
The fax reads the document into memory and begins sending.
To cancel a transmission, press [Stop] during dialing or transmission. All transmissions in
the sequence are canceled.
26 Sending Faxes
= 9 locations
= 100 locations (60 locatitons for the
FAX-JX200/JX201 models)
= 1 location