Remove Oa Dns Ipv6; Remove Snmp Trapreceiver; Remove Trusted Host - HP BL480c - ProLiant - 4 GB RAM User Manual

REMOVE OA DNS IPV6

•
Command:
REMOVE OA DNS IPV6 {<OA bay number>} <ipv6 address{/prefix length}>
•
Description:
Removes the specified DNS IPv6 address from the list of DNS addresses for the specified Onboard
Administrator. If a bay number is not specified, then the command defaults to the active Onboard
Administrator.
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
A maximum of two DNS servers can be added.
o
The <ip address> must be in the form ####:####:####:####:####:####:####:#### or
o
####:####:####:####:####:####:####:####/### (with a prefix), where each ####
ranges from 0 to FFFF and the prefix /### ranges from 0 to 128.

REMOVE SNMP TRAPRECEIVER

•
Command:
REMOVE SNMP TRAPRECEIVER <host> {"<community name>"}
•
Description:
Removes an IP address from the list of systems that receive SNMP traps. If the same IP address is
o
listed multiple times with different communities, all instances of the IP address disappear unless
<community> specifies which one is to be removed.
Removes an existing trap receiver from the SNMP configuration. If the same <host> is listed
o
multiple times with different communities, all instances of the <host> disappears unless
<community name> specifies which one is to be removed.
The <host> value can be either an IPv4 address, an IPv6 address, or a DNS name.
o
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
IPv6 addresses cannot specify the network prefix length.

REMOVE TRUSTED HOST

•
Command:
REMOVE TRUSTED HOST <ip address>
•
Description:
Removes an IPv4 or IPv6 address from the list of addresses being handled by the IP Security feature.
•
Access level/Bay level:
OA administrator, OA operator
Enclosure network configuration commands 91