Set Device Serial_Number Blade; Set Factory; Set Script Mode - HP BL480c - ProLiant - 4 GB RAM User Manual

•
Restrictions:
The <number> value cannot be greater than 99999 or negative.
o
The <ip address> value must be in the form ###.###.###.###, where each ### ranges from 0
o
to 255.
For IPv6 the <ip address> must be in the form ####:####:####:####:####:####:####:####
o
where each #### ranges from 0 to FFFF.

SET DEVICE SERIAL_NUMBER BLADE

•
Command:
SET DEVICE SERIAL_NUMBER BLADE <bay number> "<serial number>"
•
Description:
Sets the serial number of the specified Storage, Tape, or I/O expansion blade.
•
Access level/Bay level:
OA administrator
•
Restrictions:
Length must be 10 characters. All printable characters are allowed.
o
This operation cannot be performed on server blades.
o

SET FACTORY

•
Command:
SET FACTORY
•
Description:
Restores the Onboard Administrator to its factory defaults. The Administrator account password
o
does not change.
The Onboard Administrator restarts after all changes are made.
o
All existing settings will be lost when this operation is run.
o
•
Access level/Bay level:
OA administrator
•
Restrictions:
None

SET SCRIPT MODE

•
Command:
SET SCRIPT [MODE] {ON | OFF}
•
Description:
Ceases all prompting and verifying of entries when SCRIPT MODE is on.
o
The ADD USER command must have a password argument if executed in SCRIPT MODE.
o
General management commands 45