Brother PT-2420PC Service Manual page 56

Hide thumbs Also See for PT-2420PC:

Table of Contents

Note: If any error message appears in the Results area, click the Stop the feed cut test

button and then click the Finish checking and exit button to abort the test program.

Go to the recovery procedure given in Appendix 1.5.

(10) Push down the cutter lever to cut the tape.

The PT-2420PC will feed the tape again.

Note: If the tape will not feed, click the Stop the feed cut test button to stop the test.

Then check the tape cassette. If the tape has run out, remove the cassette and go

back to step (8). If not so, the cutter sensor may be defective. Click the Finish

checking and exit button to abort the test program.

Table of Contents