If The Indicator Led On The Pt-2420Pc Lights Or Flashes - Brother PT-2420PC Service Manual

4.3 IF THE INDICATOR LED ON THE PT-2420PC LIGHTS OR FLASHES

Check the LED state that shows the current machine status as listed below.
Indicator LED
ON
Flashing slowly
(In a cycle of 0.3-
second ON and 0.3-
second OFF)
Flashing quickly
(In a cycle of 0.1-
second ON and 0.1-
second OFF)
Flashing intermittently
(In a cycle of 0.1-
second ON and 0.3-
second OFF)
Flashing very slowly
(In a cycle of 1.0-
second ON and 1.0-
second OFF)
Machine status
In the standby mode for data reception.
The machine has received data.
No tape cassette is loaded.
(The controller checks the cassette loading state
at the start of data reception and printing.
During printing, no check is made.)
The tape has run out. Tape replacement is
required.
(The controller checks the tape state at
the start of printing.)
Communications error.
Cutter sensor error.
(The controller checks the sensor state at the
start of data reception and printing, and during
printing.)
EEPROM error.
On halt for cooling down the print head.
IV - 2
Remarks
Upon receipt of a print
command, the machine will
start printing.
Remove the error factor
and press the ON/OFF
button. The machine will
switch to the standby mode
for data reception.
If this error occurs, only the
ON/OFF button is enabled.
This error will not be
signaled to the connected
computer.