Brady BBP81 User Manual page 85

Telnet
Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be
used when running Vx.15.x or later firmware. In this example, a ZPL II command is used to
cause a label to print.
Note • You do not need to open a telnet session if you pinged the printer using the previous
procedure. The purpose of these two procedures is to identify whether your PC can
communicate with your printer.
To open a telnet session on your PC, complete these steps:
1. Open a DOS window.
To open a DOS window, click on
2. In the
3. From the DOS prompt, type:
This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.
Enter ~WC.
4.
This ZPL command will print a configuration label on your printer.
Click the
5.
If the configuration label prints, the issue is not a communication problem between the printer,
the print server, or the PC.
07/18/2008
Open text box, type: cmd
telnet xxx.xxx.xxx.xxx 9100
where xxx.xxx.xxx.xxx is the IP address of the print server.
X in the upper right-hand corner of the window
BradyConnect 10/100 Internal Print Server User Guide
Start > Run.
to
Hardware Troubleshooting
Troubleshooting the 10/100 PS
exit.
Y885775
85