Brady BBP81 User Manual page 24

24 10/100 Internal Print Server
10/100 Internal PS Features
TCP/IP Configuration
You can change the TCP/IP configuration of
the 10/100 Internal PS.
•
•
•
•
•
•
•
•
•
•
Y885775
IP Address: Use this feature to set the IP
address if using the Permanent addressing
method.
IP Address Resolution: Use this feature to
select the addressing method to use
(Dynamic or Permanent).
Dynamic Protocols: Use this feature to
select the Dynamic Addressing method to use
at startup. Choices include RARP, BOOTP,
DHCP, Gleaning or Default Address.
Subnet Mask:
Use this feature to set the
subnet mask. The subnet mask must follow
the format XXX.XXX.XXX.XXX, where
each XXX is a number between 0 and 255.
Default Gateway:
Use this feature to set the
default gateway. This gateway will be used
whenever messages need to be sent to
another network. This gateway address must
follow the format XXX.XXX.XXX.XXX,
where each XXX is a number between 0 and
255.
WINS Server IP Address:
to set or view the IP address of the WINS
Server.
Connection Timeout Checking:
feature to enable or disable the Connection
Timeout feature. The timeout is used to close
network TCP/IP connections that are idle for
more than the number of seconds entered in
the Timeout Value.
Timeout Value (secs):
Use this feature to
set the Connection Timeout Value. The Valid
range is 10 to 3600 seconds. The default is
300 seconds.
ARP Broadcast Interval (mins):
feature to set interval for sending an ARP
Broadcast. The valid range is 1 to 30 minutes.
Address Resolution Protocol (ARP)
broadcast packets allow other network
devices to associate the print server's IP
Address with its hardware address.
Base Raw Port Number:
to set the raw TCP port that the print server
will use for printing tasks. The default is port
9100.
BradyConnect 10/100 Internal Print Server User Guide
Table 4 • Menu Options
Use this feature
Use this
Use this
Use this feature
07/18/2008