Cleaning The Oil Pad - Brother HL-3450CN Service Manual

CHAPTER 6 PERIODIC MAINTENANCE
2.10

Cleaning the Oil Pad

The oil pad should be cleaned according to the periodic maintenance cleaning cycle set out
in Table 6-3.
When time is due for replacement of the oil pad, the following message appears on the
control panel.*
* The message can be turned OFF to prevent it from appearing on the control panel. Refer
to 32 NEXT CARE INFORMATION, Section 3.3 of Chapter 5.
Tools to Prepare
N
Slotted screwdriver
Cleaning Procedure
(1) Turn off the power supply, and unplug the power cable.
(2) Open the top cover.
(3) Remove the fusing unit from the printer and then remove the oil bottle and the fuser
cleaner form the fusing unit.
(4) Remove the oil pan unit from the fusing unit.
(5) Scour off toner scattered on the white felt surface of the oil pad and on the surface of the
oil blade using the head edge of a slotted screwdriver.
N
Do not scrub the felt too hard, otherwise it may cause damage to it.
REPLACE OIL PAD
CAUTION
Oil blade
Fig. 6-11
6-18
White felt