CHAPTER 5 CONTROL PANEL OPERATION
Code No.
16-4
16-5
16-6
17
18
LCD Message
ALIGN BELT CG
16 ALIGN BELT CG
[*4]
ALIGN LFU
16 ALIGN LFU
[*4]
ALIGN TRANSFER ROLLER
16 ALIGN BELT CG
[*4]
MEDIA JAM
17 MEDIA JAM
[*7]
[*4]
CLOSE PANEL
18 CLOSE PANEL
[*8]
[*4]
Description of Message
x
The engine is stopped.
x
The Power LED is lit.
x
The OPC belt cartridge is not
installed. Reconfirm the installation
status of the OPC belt cartridge.
x
This message will be automatically
cleared by opening & closing either
the paper exit cover or front cover.
x
The engine is ready to print.
x
Turn the power off and connect the
harness between the engine and
fusing unit.
x
Turn the power on. If the warming-up
process starts, it means that proper
connection is now made.
x
The engine is ready to print.
x
The Power LED is lit.
x
The transfer roller is not installed.
Reconfirm the installation status of the
transfer roller.
x
This message will be automatically
cleared by opening & closing either
the paper exit cover or front cover.
x
The engine is stopped.
x
The Power LED is lit.
[*7]: The kind of jam (location of jam) is
indicated as follows;
FEED:
INNER:
OUTER:
DRUM:
DPL:
x
This message can be cleared by
pressing the - button after opening &
closing the front cover, back cover
and paper exit cover.
x
The engine is ready to print.
x
The Power LED is lit.
[*8]: The open cover is indicated as
follows;
FRONT:
TOP:
REAR:
DPL:
LFU:
x
This message can be cleared by
opening & closing the indicated cover.
5-18
Paper feeder
Inside of the printer
Paper exit unit
Transfer drum
Inside the duplex unit
Front cover
Paper exit cover
Rear access cover
Rear access cover
Fusing unit cover