Erase Lamp 3 / Erase Holder - Brother HL-3450CN Service Manual

CHAPTER 7 DISASSEMBLY & RE-ASSEMBLY
NOTE:
N
For easier removal, push the drum upwards and diagonally forwards.
N
When re-assembling the transfer drum 3, slide the drum shaft between the metal plates
and ensure the drum is fully located into the correct retaining position.
Do not touch the transfer drum surface with your bare hands or scratch it. Protect the drum
surface during handling.
4.2.11

Erase lamp 3 / Erase holder

(1) Disconnect the harness (1 pc.) connected to the erase lamp 3.
(2) Remove the erase lamp 3 from the holder.
NOTE:
When re-assembling the erase lamp 3, check the correct direction referring to the figure
below. Failure to do so may cause transfer drum damage.
Holder
Erase holder
Harness
Erase holder
Fig. 7-41
(Left Side)
Fig. 7-42
7-30
PRECAUTION
Erase lamp 3
(Right Side)