Copying The Data; Specifying And Storing The Start Pint; Specifying And Storing The End Point - Fostex DMT-8 Supplement Owner's Manual

Copying the data

* The following procedure is based on data with the ABS Time Base.
To change the Time Base to MTC or MIDI BAR/BEAT CLK, press
the DISP SEL key while pressing and holding down the EXECUTE/
YES key.
Specifying and storing the Start point (Clipboard In point)
1. Press the RECALL key, then the CLIPBOARD IN key (or predd only the
CLIPBOARD IN key) to enter edit mode.
2. Select the digit to edit using the HOLD/> key on the SHUTTLE dial, and
use the JOG dial to set a desired time value.
3. Press the STORE key, then the CLIPBOARD IN key.
The specified time will be stored at the CLIPBOARD IN key as the copy start
point (clipboard In point), and the DMT-8 will quit edit mode, displaying the
previous screen.
* You can store the start point in real-time instead of following Steps
1-3 described above. (While playing back the data, predd the
STORE key, the CLIPBOARD IN key.)
Specifying and storing the End point (Clipboard In point)
4. Press the RECALL key, then the CLIPBOARD OUT key (or predd only the
CLIPBOARD OUT key) to enter edit mode.
* To check to see if the correct In/Out points have been stored, press
the CLIPBOARD IN/CLIPBOARD OUT keys. The display will
show the stored time value.
DMT-8 Ver 2.0 Supplement to the Owner's Manual
7