Table of Contents
Advertisement
Status Request
Status request command
Controller to D-80/DMT-8 ver 2.0
Loop op. status
Loop status
Post locate status
Auto rec status
Lock status
Copy clip status
Copy paste status
Erase status
Nondes. mode
Move clip status
Nove paste status
Digital in ch. st.
Digital out ch. st.
Program status
Click status
Level status
< Note 1>
Nondes. mode:
Abbreviation for "non destructive recording mode". When this mode is ON, not
only "takes" made by various sound editing or AUTO PUNCH IN/OUT but "takes"
recorded by simultaneous pressing of the PLAY and RECORD buttons (direct
recording) will always be possible to UNDO (However, free disc memory space
equivalent to the recording length will always be required). This is the same
function of switching between "undo:ALL (Nondes.momde:on) <– –> Edit (Nomdes.
mode: off )" in the setup menu on the main unit.
< Note 2>
There is a limitation on specifying the <channel><channel> setting. For details,
refer to "Explanation on Command/Mode Set" mentioned in later pages.
EXPLANATION ON READ/WRITE INTO THE VARIOUS EDIT POINT MEMORY
The MMC response/information field "GP0~GP6" are allotted in the edit point
memories (clipboard in, clipboard out, auto punch in, auto ounch out memory, etc.)
which is necessary at editing. Therefore, at registering and readout of the edit point
memory, the "WRITE (40)" command and the "READ (42)" command of MMC must be
used. Relationship berween the Edit point memory of D-80/DMT-8 ver2.0 and GP0~
GP6 are shown below:
<Response/Information Field>
08 GP0 : locate memory
0A GP2 : clipboard out memory
0C GP4 : auto punch in memory
0E GP6 : end memory
DMT-8 Ver 2.0 Supplement to the Owner's Manual
Status reply
D-80/DMT-8 ver 2.0 to controller
22 21
32 21 (<Loop op. mode = 12>)
22 22
32 22 (<on/off>)
22 28
32 28 (<post locate status>)
22 2D
32 2D (<edit message>)
22 41
32 41 (<lock status>)
22 45
32 45 (<edit message=01 or =14>)
32 46 (<edit message=02><mmc time>)
22 46
or
32 46 (<edit massage=00>)
32 47 (<edit message=02><mmc time>)
22 47
or
32 47 (<edit message=00>)
22 4C
32 4C (<on/off>)
22 4D
32 4D (<edit message=01 or =14>)
32 4E (<edit message=02><mmc time>)
22 4E
or
32 4E (<edit message=00>)
23 41
32 41 (<channel><channel>)
23 42
33 42 (<channel><channel>)
23 43
33 43 (<program>)
23 44
33 44 (<on/off>)
23 45
33 45 (<count=08><level data>)
31
09 GP1 : clipboard in memory
0B GP3 : start memory
0D GP5 : auto punch out memory
0F GP7 : reserved
Advertisement
Table of Contents
