Table of Contents
Advertisement
DMT-8 Ver 2.0 Supplement to the Owner's Manual
2. Specify the move destination track and the number of repeats to paste.
3. Press the EXECUTE/YES key.
The upper row of the display will show the time taken for the Move & Paste
operation, then "MoVE", "PASt", then "COMPLETED!", Press the EXIT/NO key to
go back to the previous screen.
Now the audio data on the Clipboard has been pasted to the specified
track starting with the Auto Punch In point.
Unlike the Copy & Paste operation, executing the Move & Paste function
will erase the original data and the data on the Clipboard.
For example, executing the function with a repeat number of "rPt 03"
(three times) will paste the data as shown in the diagram below.
Repeat number of "03"
* To cancel the Move & Paste operation, press the EXIT/NO key when the
display shows blinks the "ARE YOU SURE?" message. If you wish to
abort the paste operation after you have pressed the EXECUTE/YES key,
press the STOP button or the EXIT/NO key before the display shows
"COMPLETED!", indicating the completion of the paste operation. If
you cancel or abort the press operation in these ways, no part of the
copied data will be pasted at all. (Even if you abort an operation in
progress, nothing will be pasated.)
< Note>
The data on the Clipboard will be cleared after the Move & Paste function
is executed. Therefore, you cannot paste the same data again.
* Specifying the move & paste designation track;
Select the destination track using the RECORD TRACK select key. (You do
not need to specify the track if you are going to move & paste data in the
copy source track.)
* Specifying the number of repeats to move & paste;
Turn the JOG dial to change the blinking number "01" to any value between
01 and 99. (if there is not enough free space on the hard disk, the repeat
time will be limited to a number less than 99, and you will be unable to
specify a large number when you turn the JOG dial.)
Auto Punch In Point
1
2
12
3
Advertisement
Table of Contents
