Table of Contents
Advertisement
3-2. Setting the MTC offset time ("MTC OFFSET")
Available offset time range in Version 2.0 is 0H:00M:00S:00SF through
5H:59M:59S:29F:99SF. This setting is effective only in the selected Program.
3-3. Setting a digital input channel ("dG in")
Using "dG in" of Setup menu, you can assign any of the analog inputs 1-8
to digital inputs L and R. This assignment will allow you to record digital
data from an external digital device (such as CD, MD, etc.) to the DMT-8
through DATA IN. (You can record data directly to the hard disk, without
using an A/D converter.) This setting will be shared by all Programs.
Turning the power off will set this setting to "OFF".
1. Press the DISP SEL key to select "SETUP" and press the EXECUTE/YES
key. (The "SETUP" indicator will light up.) Turn the JOG dial to select
the blinking "dG in".
The display will change to something like this, and the current value will appear.
(The default setting is "L -", "R -", indicating that both are off.)
1
2. Press the EXECUTE/YES key again.
Letter "L -" on the display will blink, and you can now edit the value.
1
3. Use the SHUTTLE dial to select blinking "L -" or "R -", and turn the JOG
dial to input numeric data (1-8).
4. Press the EXECUTE/YES key again.
The display in Step 1 will appear, and the setting is complete.
5. Press the STOP button or the EXIT/NO key to quit Setup mode.
< CAUTION >
You cannot use the tracks for analog recording iff they are assigned to digital
input. Therefore, return this parameter to the "OFF" setting after digital
recording is complete.
< Note >
If you assign the same track to both digital inputs L and R, the L channel will
have priority and the R channel will automatically be "OFF".
DMT-8 Ver 2.0 Supplement to the Owner's Manual
2
3
4
5
6
7
8
OVER
0
3
6
9
12
18
24
30
2
3
4
5
6
7
8
OVER
0
3
6
9
12
18
24
30
19
L
R
SET UP
L
R
SET UP
Blink
Blink
Advertisement
Table of Contents
