Explanation On The Command/Mode Set - Fostex DMT-8 Supplement Owner's Manual

Explanation on the Command/Mode Set

12 22 (<on/off>): loop on/off command
The command for setting the "loop mode on/off" (=ON/OFF of AUTO RTN) of D-80/
DMT-8 ver2.0. Default figure of the loop operation mode is "12=stop" and this cannot be
changed.
12 28 (<post locate mode): post locate command
The command for setting the "post locate mode" (=ON/OFF of AUTO PLAY) of D-80/
DMT-8 ver2.0. It will stop after locating if "post locate mode=12." It will enter play after
locating if "posy locate mode=15."
12 2D (<on/off>): auto rec command
The command for setting "auto rec mode on/off" (=ON/OFF of AUTO PUNCH) of D-80/
DMT-8 ver2.0. Upon receiving this command, D-80/DMT-8 ver2.0 will immediately reply
the operating condition by sending "32 2D (<edit message>)".
12 41 (<lock enable>): lock enable command
The command for setting "slave mode on/off" (setup menu) of D-80/DMT-8 ver2.0.
12 45 (<count><mmc track>): copy clip command
When this command is received, D-80=DMT-8 ver2.0 will copy (multiple number of tracks
can be copied simultaneously) the sound data, as data for copy paste, from the pre-
registered clipboard-in point to the clipboard-out point in the track specified by
<mmc track>.
With completion of copying the data into the clipboard, D-80/DMT-8 ver2.0 will
immediately reply with "32 45 (<edit message=01 (completed)>)".
If copy cannot be executed due to improper figures of the pre-registered clipboard in/
clipboard out points or incorrect track section, the corresponding <adit message> will be
returned.
12 46 (<count=1><repeat count>): copy paste command
12 46 (<count><repeat count><mmc track>): copy paste command
When this command is received, D-80=DMT-8 ver2.0 will paste the sound data which
has been copied into the clipboard, on the same track from the pre-registered auto punch
in point ever, if the sound data length in the clipboard is less than 10ms, the specifying
the <repeat count> will be limited to "01."
Also, by specifying <mmc track>, paste can be executed on other tracks in mono (in one
track units) or stereo units (in combinations of tracks 1 & 2, 3 & 4, 5 & 6, 7 & 8).
Since time corresponding to length of the copy clipped sound data is required to complete
the copy paste operation, D-80/DMT-8 ver2.0 immediately replies with "32 46 (<edit
mcssage=02 (active)>)" after receiving the command.
Successively upon completing the paste operation, "323 46 (<edit message=01
(completed)> " is transmitted.
If paste cannot be executed due to improper figures of the pre-registed auto punch in
point, insufficient disc capacity, no sound data in the clipboard, etc., the corresponding
<editmessage> will be replied.
12 47 (<count><mmc track>): erase command
When this command is received, D-80=DMT-8 ver2.0 will erase the data (writes in "0"
data) in the section from the pre-registered auto punch in point through auto punch
out point in the track specified by <mmc track>. Since time corresponding to length of
the erase section is required to complete the erase operation, D-80/DMT-8 ver2.0 will
immcdiately reply by "32 47 (<edit message=02 (active)>)" after receiving the command.
DMT-8 Ver 2.0 Supplement to the Owner's Manual
33