Brady BP-PR 300 PLUS Series User Manual page 26

BP-PR PLUS Series
Parameter
Backfeed
Error-Reprint
Pause reprint
Protocol error
Barcode error
Width ASCII
dump
20
Method for backfeeding the label medium. Backfeeding is
necessary in the cutting and peel-off modes since a label is
pushed out passed the front edge of the next label above the print
line when peeling off/cutting. always: Backfeeding occurs
independently of label contents. smart: Backfeeding only occurs
when the next label is not yet fully prepared when peeling off/
cutting the current label. Otherwise, the second label is pushed on
and completed after removal of the first label without backfeeding.
On: With a correctable error and corresponding troubleshooting,
the label being printed when the error occurs is repeated. Off: Print
job is continued with the next label.
Printing of another label with the information of the previous print
job by pressing the pause button. This function can be executed
until the print buffer is cleared with the cancel button.
On: Printer switches to Error mode when unknown or faulty data is
received. Off: When working with older computer operating
systems, it is possible that the print spooler of the operating
system will reply to the printer with normal status messages of the
printer (e.g. end of paper) in the form of ASCII text. The printer
cannot interpret this data and outputs a large number of protocol
errors. In this case, it is advantageous if you set the Protocol
error parameter to Off. Caution: If the Protocol error parameter
is set to Off, protocol errors which can be traced back to faulty
programming are also ignored. There is a risk of data loss.
On: With faulty barcode contents or size specifications, printing is
interrupted. Off: Printing is not interrupted if an error occurs. If
barcode contents are faulty, the printer attempts to replace the
incorrect data with valid characters (e.g. zeros). If barcode size
specifications are faulty, a gray area is printed instead of the
barcode.
Width of printing area in the "Monitor mode" test function (see 5-6
ASCII Dump Mode on page 40). With the Automatic setting, the
printout of the control sequences arriving at the printer occurs over
the maximum printing width. You can reduce the printing area
width down to 50 mm.
Table 9. Parameters of the menu Setup > Print param.
User Manual
Meaning Default
smart
On
Off
On
On
Automatic
Edition 04/10