Using The Cli To Configure Dynamic Interfaces - Cisco SD2008T-NA Configuration Manual

Chapter 3 Configuring Ports and Interfaces
Configure the following parameters:
Step 5
•
•
•
•
•
•
Note
Click Save Configuration to save your changes.
Step 6
Repeat this procedure for each dynamic interface that you want to create or edit.
Step 7

Using the CLI to Configure Dynamic Interfaces

Follow these steps to configure dynamic interfaces using the CLI.
Enter show interface summary to view the current dynamic interfaces.
Step 1
To view the details of a specific dynamic interface, enter show interface detailed
Step 2
operator-defined-interface-name.
Enter config wlan disable wlan-number to disable each WLAN that uses the dynamic interface for
Step 3
distribution system communication.
OL-9141-03
VLAN identifier
Fixed IP address, IP netmask, and default gateway
Physical port assignment
Quarantine
Check the Quarantine check box if you want to configure this VLAN as unhealthy. Doing
Note
so causes the data traffic of any client that is assigned to this VLAN to pass through the
controller, even if the WLAN is configured for local switching. This command is generally
used for clients that are associated to a hybrid-REAP access point and the access point's
controller is configured for network access control (NAC). See
information on hybrid REAP.
Primary and secondary DHCP servers
Access control list (ACL) name, if required
Note See Chapter 5 for more information on ACLs.
To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
Configuring Dynamic Interfaces
Chapter 12
Cisco Wireless LAN Controller Configuration Guide
for more
3-17