Using The Cisco Ios-Xe Cli-Manual Configuration - Cisco Catalyst 9800-80 Installation Manual

Using the Cisco IOS-XE CLI Manual Configuration
Step 2
When messages stop appearing on your screen, press Return to get the
Step 3 The prompt indicates that you are now at the command-line interface (CLI).
WLC>
You have just completed an initial controller configuration. Note that this is not a complete configuration. At this point,
you have two choices:
• Run the setup command facility again, and create another configuration:
WLC> enable
Password: password
WLC# setup
• Modify the existing configuration or configure additional features by using the CLI:
WLC> enable
Password:
WLC# configure terminal WLC(config)#
Using the Cisco IOS-XE CLI Manual Configuration
This section shows you how to access the CLI to perform the initial configuration on the controller
If the system configuration message does not appear, it means a default configuration file was installed on
the controller prior to shipping.
Follow these steps to configure the controller.
Step 1
Enter no when the following system message appears on the controller.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2 Press Return and continue with the manual configuration:
Several log messages are displayed.
Step 3
Press Return to bring up the
Step 4 Type enable to enter privileged EXEC mode.
WLC> enable
WLC#
The following table covers details about the auto boot, boot file mentioned, and message displayed.
Auto Boot (Set/Not Set)
Set
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
60
password
prompt
WLC>
Boot File Mentioned
No
Power Up and Initial Configuration
prompt.
WLC>
Message displayed
You get to view a warning message and
require confirmation to proceed with
the reload without mentioning a file to
boot with. You get to view this message
apart from the regular confirmation on
the usual reload.