Wlan Overview - Cisco SD2008T-NA Configuration Manual

WLAN Overview

WLAN Overview
The Cisco UWN Solution can control up to 16 WLANs for lightweight access points. Each WLAN has
a separate WLAN ID (1 through 16), a separate WLAN SSID (WLAN name), and can be assigned unique
security policies.
Lightweight access points broadcast all active Cisco UWN Solution WLAN SSIDs and enforce the
policies that you define for each WLAN.
Note Cisco recommends that you assign one set of VLANs for WLANs and a different set of VLANs for
management interfaces to ensure that controllers properly route VLAN traffic.
Configuring WLANs
These sections describe how to configure WLANs:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Displaying, Creating, Disabling, and Deleting WLANs
On the controller CLI, enter these commands to display, create, disable, and delete WLANs:
•
•
Cisco Wireless LAN Controller Configuration Guide
6-2
Displaying, Creating, Disabling, and Deleting WLANs, page 6-2
Activating WLANs, page 6-3
Configuring DHCP, page 6-3
Configuring MAC Filtering for WLANs, page 6-6
Assigning WLANs to VLANs, page 6-6
Configuring Layer 2 Security, page 6-7
Configuring Layer 3 Security, page 6-14
Configuring 802.3 Bridging, page 6-17
Configuring Quality of Service, page 6-17
Configuring Cisco Client Extensions, page 6-22
Configuring Access Point Groups, page 6-26
Configuring Multiple WLANs with the Same SSID, page 6-30
Configuring Conditional Web Redirect with 802.1X Authentication, page 6-32
Disabling Accounting Servers per WLAN, page 6-35
Enter show wlan summary to display existing WLANs and whether they are enabled or disabled.
Note that each WLAN is assigned a WLAN ID from 1 to 16.
Enter config wlan create wlan-id wlan-name to create a new WLAN. For wlan-id, enter an ID from
1 to 16. For wlan-name, enter an SSID of up to 31 alphanumeric characters.
Chapter 6 Configuring WLANsWireless Device Access
OL-1926-06OL-9141-03