Using The Cli To Configure Dynamic Interfaces - Cisco OL-8335-02 Configuration Manual

Configuring Dynamic Interfaces
Configure the following parameters:
Step 5
•
•
•
•
•
Note
Click Save Configuration to save your changes.
Step 6
Repeat this procedure for each dynamic interface that you want to create or edit.
Step 7

Using the CLI to Configure Dynamic Interfaces

Follow these steps to configure dynamic interfaces using the CLI.
Enter show interface summary to view the current dynamic interfaces.
Step 1
Step 2 To view the details of a specific dynamic interface, enter show interface detailed
operator-defined-interface-name.
Step 3 Enter config wlan disable wlan-number to disable each WLAN that uses the dynamic interface for
distribution system communication.
Enter these commands to configure dynamic interfaces:
Step 4
•
•
•
•
•
•
3-16
VLAN identifier
Fixed IP address, IP netmask, and default gateway
Physical port assignment
Primary and secondary DHCP servers
Access control list (ACL) name, if required
To create ACLs, follow the instructions in
Note
To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
config interface create operator-defined-interface-name {vlan-id | x}
Enter a non-zero value for the VLAN identifier. Tagged VLANs must be used for dynamic
Note
interfaces.
config interface address operator-defined-interface-name ip-addr ip-netmask [gateway]
config interface vlan operator-defined-interface-name {vlan-id | 0}
config interface port operator-defined-interface-name physical-ds-port-number
config interface dhcp operator-defined-interface-name ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl operator-defined-interface-name access-control-list-name
To create ACLs, follow the instructions in
Note
Chapter 3 Configuring Ports and Interfaces
Chapter 5.
Chapter 5.
Cisco Wireless LAN Controller Configuration Guide
OL-8335-02