Using The Cli To Configure Ccx Client Roaming Parameters - Cisco SD2008T-NA Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
In the Scan Threshold field, enter the RSSI value, from a client's associated access point, below which
Step 5
the client must be able to roam to a neighboring access point within the specified transition time. This
parameter also provides a power-save method to minimize the time that the client spends in active or
passive scanning. For example, the client can scan slowly when the RSSI is above the threshold and scan
more rapidly when below the threshold.
Range: –70 to –72 dBm
Default: –72 dBm
In the Transition Time field, enter the maximum time allowed for the client to detect a suitable
Step 6
neighboring access point to roam to and to complete the roam, whenever the RSSI from the client's
associated access point is below the scan threshold.
The Scan Threshold and Transition Time parameters guarantee a minimum level of client roaming
performance. Together with the highest expected client speed and roaming hysteresis, these parameters
make it possible to design a wireless LAN network that supports roaming simply by ensuring a certain
minimum overlap distance between access points.
Range: 1 to 10 seconds
Default: 5 seconds
Step 7 Click Apply to commit your changes.
Step 8 Click Save Configuration to save your changes.
Repeat this procedure if you want to configure client roaming for another radio band (802.11a or
Step 9
802.11b/g).

Using the CLI to Configure CCX Client Roaming Parameters

To configure CCX Layer 2 client roaming parameters, enter this command:
config {802.11a | 802.11bg} l2roam rf-params min-rssi rssi_value roam-hyst hyst_value scan-thres
thres_value trans-time time_value
Note
Use these commands to view information about CCX Layer 2 client roaming.
1.
2.
Ol-9141-03
See the description, range, and default value of each RF parameter in the
Configure CCX Client Roaming Parameters" section on page
To view the current RF parameters configured for client roaming for the 802.11a or 802.11b/g
network, enter this command:
show {802.11a | 802.11bg} l2roam rf-params
To view the CCX Layer 2 client roaming statistics for a particular access point, enter this command:
show {802.11a | 802.11bg} l2roam statistics ap_mac
This command provides the following information:
– The number of roam reason reports received
– The number of neighbor list requests received
The number of neighbor list reports sent
–
The number of broadcast neighbor updates sent
–
4-20.
Cisco Wireless LAN Controller Configuration Guide
Configuring Client Roaming
"Using the GUI to
4-21