Assigning Access Points To Access Point Groups - Cisco SD2008T-NA Configuration Manual

Chapter 6 Configuring WLANsWireless Device Access
Using the CLI to Create Access Point Groups
To create an access point group, enter this command:
config ap group-name group_name

Assigning Access Points to Access Point Groups

After you have created your access point groups, use the GUI or CLI to assign access points to these
groups.
Using the GUI to Assign Access Points to Access Point Groups
To assign an access point to an access point group, follow these steps:
Click Wireless > Access Points > All APs.
Step 1
Click the Detail link for the access point.
Step 2
Select the access point group from the AP Group Name drop-down box (see
Step 3
Figure 6-12 All APs > Details Page
Step 4 Click Apply.
Click Save Configuration to save your changes.
Step 5
Using the CLI to Assign Access Points to Access Point Groups
To assign an access point to an access point group, enter this command:
config ap group-name group_name ap_name
OL-1926-06OL-9141-03
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
Figure 6-12).
6-29