Using The Cli To Configure The Ap-Manager Interface - Cisco SD2008T-NA Configuration Manual

Chapter 3 Configuring Ports and Interfaces
Note
Enter config wlan disable wlan-number to disable each WLAN that uses the management interface for
Step 2
distribution system communication.
Enter these commands to define the management interface:
Step 3
•
•
•
•
•
Enter save config to save your changes.
Step 4
Enter show interface detailed management to verify that your changes have been saved.
Step 5

Using the CLI to Configure the AP-Manager Interface

Follow these steps to display and configure the AP-manager interface parameters using the CLI.
Step 1 Enter show interface summary to view the current interfaces.
Note
Step 2 Enter show interface detailed ap-manager to view the current AP-manager interface settings.
Enter config wlan disable wlan-number to disable each WLAN that uses the AP-manager interface for
Step 3
distribution system communication.
OL-9141-03
The management interface uses the controller's factory-set distribution system MAC address.
config interface address management ip-addr ip-netmask gateway
config interface vlan management {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
that only tagged VLANs be used on the controller.
config interface port management physical-ds-port-number
config interface dhcp management ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl management access-control-list-name
See Chapter 5 for more information on ACLs.
Note
If the system is operating in Layer 2 mode, the AP-manager interface is not listed.
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Cisco Wireless LAN Controller Configuration Guide
3-13