Olivetti Fax-Lab 480 Instructions Manual page 44

2. Press the key
until the display shows:
You can choose one of the following reaction times:
"15", "20", "30", "40",
3. To do so, repeatedly press the key:
/
4. To confirm the selection, press the key:
5. To return the fax machine to the stand-by mode, press the
key:
C
HANGING THE SILENCE LAPSE
This function is only enabled in some countries.
If no message is received within the preset time, the fax
machine automatically prepares to receive a document.
To change the preset silence lapse, proceed as follows:
1. Press the key
until the display shows:
2. Press the key
until the display shows:
You can choose the following silence lapses: "3", "4", "6",
"8", "10" and "OFF"
3. To do so, repeatedly press the key:
/
4. To confirm the selection, press the key:
5. To return the fax machine to the stand-by mode, press the
key:
N o t e
If you connect an external telephone answering device, make
sure that the silence lapse after which the answering device is activated
is less than the one set on the fax machine.
38
C
HANGING THE FAX MACHINE REMOTE OPERATION CODE
You can enable reception on the fax machine from a remote
telephone. The fax machine must be set up for manual
reception and the remote telephone must use tone dialling.
Type in the code ** for remote fax operation on the remote
telephone. This operation has the same effect as pressing
the key on the fax machine.
You can replace the second asterisk of this code using digits
from 0 to 9.
1. Press the key
until the display shows:
2. Press the key:
The display shows:
3. Press the key:
The display shows the line to which the fax machine was set
to be connected, for example:
4. Press the key
until the display shows:
5. Press the key:
The display shows the code you set previously, for example:
Enter the new code (e.g. "*9").
6. To do so, press the key:
-
7. To confirm the selection, press the key:
8. To return the fax machine to the stand-by mode, press the
key:
N o t e
To disable this function
1. Press |/} after the fourth step to display "REMOTE START:OFF".
2. To confirm the entry, press the
3. Press the key.
The fax machine returns to the stand-by mode.
N o t e
If you are connected to a private line, follow the same procedure until
the display shows "PUBL.LINE (PSTN)", press the |/} keys to display:
"PRIV.LINE (PBX)" and then continue as described in the procedure.
key.