Mazda 6 Owner's Manual page 313

Mazda6_8CJ2-EA-12C_Edition1 Page313
Monday, January 30 2012 10:10 AM
NOTE
The system may not operate normally
l
depending on the Bluetooth
To make sure that your Bluetooth
l
device is Ver. 1.0 or 1.3, refer to the
Owner's Manual for the Bluetooth
device.
It may not be possible to play a Bluetooth
l
audio device if it is placed in a location
where transmission is compromised, such
as inside a metal container or the trunk.
Move the Bluetooth
location where transmission is possible.
The battery consumption of Bluetooth
l
audio devices is higher while Bluetooth
connected.
®
If a non-Bluetooth
l
commercially-available Bluetooth
is required. When playing an audio device
®
with a Bluetooth
programming of the audio device may not
be possible or audio may not be heard from
the vehicle speakers if the connection of the
adapter and the device is poor. If this
happens, check whether the Bluetooth
adapter is properly connected.
qBluetooth® Audio Preparation
®
Bluetooth audio device set-up
®
Bluetooth audio programming, changes,
deletions, and display of programmed
device information can be performed.
®
Bluetooth audio device programming
®
Any Bluetooth audio device must be
programmed to the vehicle's Bluetooth
unit before it can be listened to over the
vehicle's speakers.
A maximum of seven devices including
®
Bluetooth audio devices and hands-free
mobile phones can be programmed to one
vehicle.
Form No.8CJ2-EA-12C
®
audio device.
®
audio
®
audio
®
®
audio device to a
®
®
-
device is to be used, a
®
adapter
adapter installed,
®
®
Bluetooth® Audio (Type B)
NOTE
Always perform Bluetooth
l
programming while the vehicle is stopped.
Programming cannot be performed while
l
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, "Pairing prohibited" is displayed.
A total of seven devices can be programmed
l
to one vehicle. If you require an additional
device to be programmed to a vehicle with
seven devices already programmed, delete
one of the programmed devices before
programming the latest one.
®
If a Bluetooth device has already been
l
programmed to the vehicle as a hands-free
mobile phone, it does not need to be
programmed again when using the device
®
as a Bluetooth audio device. Conversely, it
does not need to be programmed again as a
hands-free mobile phone if it has already
been programmed as a Bluetooth
device.
Look around to be sure other likely
l
®
Bluetooth audio devices are not in range
when you start to program. If in doubt,
move your car to another location. The
transmission range of a Bluetooth
device is about 10 m (32 ft). Therefore, if
there is another Bluetooth
within a 10 m (32 ft) radius of the vehicle,
the device may be identified and
programmed instead.
Device registration can also be done using
l
voice recognition (page 6-100).
Concerning the operation of a Bluetooth
audio device itself, refer to its instruction
manual.
®
Some Bluetooth audio devices have PIN
codes (four digits). Refer to the audio
device's instruction manual because the
programming procedure differs depending
on whether it has a PIN code or not.
Interior Comfort
®
audio device
®
audio
®
audio
®
audio device
®
6-89