Magnetic Safety Stop; Magnetic Safety Stop Deactivation - Nautilus T9.14 Owner's Manual

INSTALLATION & OPERATION
Magnetic Safety Stop Activation
To activate the limited-access control and restrict access, place the magnetic
safety stop cord supplied with the treadmill in the designated area located
below the display.
The magnet will activate the control. If you remove the key, the treadmill belt
will stop and the controller will not respond to any key presses. Accumulated
values will remain on the display until you turn off the power, or press [Clear].
The console will display a message, REPLACE MAGNET when you remove the
magnetic key from its designated area. You must replace the key or deactivate
the control to start the walk belt.

Magnetic Safety Stop Deactivation

To deactivate the Safety Stop Cord and permit unrestricted access of the
treadmill follow the steps below.
1. With the magnet key in place and the display at the opening message,
SELECT WORKOUT, or, if the magnet key is removed and the display reads,
REPLACE MAGNET, press [Speed UP], [3], [ENTER]. The display will read
"CUSTOMIZE". Use the [Speed UP] or [Speed DOWN] keys to scroll through
the options until the console displays ENABLE MAGKEY.
2. Press [ENTER], and the display will either read ON or OFF. Press [Speed:
+] or [Speed: -] to toggle between ON and OFF. With OFF displayed, press
[ENTER] to select OFF.
3. The display will show UPDATING for a few seconds, then display the
OFF setting.
4. Next, turn off the power to the treadmill from the circuit breaker switch. The
circuit breaker switch is located on the bottom front panel of the treadmill.
5. With the power to the treadmill off, remove the magnet key. Then, turn the
power to the treadmill back ON at the circuit breaker switch.
6. The display will show the SELECT WORKOUT screen. The limited access
control remains inactive, granting unrestricted access, until you turn the
magnetic key option back on, or place the magnet back in its designated area.
qqqqq
IMPORTANT
SAFETY CORD FEATURE REACTIVATES AUTOMATICALLY and must be turned
off again using the above steps.
If at any time the safety key is put back in place THE
Attach magnetic safety cord onto
clothing as shown.
5