Kyocera 6500i Operation Manual page 395

LDAP Security
Select the type of encryption according to the type of security employed by the LDAP server. This setup is
available when SSL is On. The default setting is Off.
NOTE:
LDAP must be set to [On] in Protocol Detail on page 9-94.
The table below shows the available settings.
Item
Off
SSL/TLS
STARTTLS
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Change] of LDAP Security.
3
Press [Off], [SSL/TLS] or [STARTTLS].
4
Press [OK].
SMTP Security
Set the protocol that can be used on the SMTP port. This setup is available when SSL is On. The default setting
is Off.
NOTE:
SMTP must be set to On in Protocol Detail on page 9-94.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network, [Next] of Secure Protocol, and then [Change] of SMTP Security.
3
Press [Off], [SSL/TLS] or [STARTTLS].
4
Press [OK].
Do not use security employed by the LDAP server.
Use implicit mode for data communication. The server provides services
using the SSL/TLS port (636). Encryption is applied to any data
communication using this port.
Use explicit mode for data communication. Select this if the server supports
the start TLS command. This uses the same port (389) as LDAP.
9-99
Default Setting (System Menu)
Description
9