Installing The Bobbin - Baby Lock ellure BLR Instruction And Reference Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Installing the bobbin

Install the bobbin wound with thread.
CAUTION
● Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
● The bobbin was designed specifically for
this sewing machine. If bobbins from
other models are used, the machine will
not operate correctly. Use only the
included bobbin or bobbins of the same
type (part code: X52800-150).
11.5 mm
(7/16 inch)
a Slide the bobbin cover latch to the right.
a Bobbin cover
b Latch
The bobbin cover opens.
b Remove the bobbin cover.
c Hold the bobbin with your right hand and hold
the end of the thread with your left.
• Be careful not to drop the bobbin.
Actual size
This model Other model
1 2
d Insert the bobbin into the bobbin case so that
the thread unrolls to the left.
• Be sure to insert the bobbin correctly.
CAUTION
● Be sure to hold down the bobbin with
your finger and unroll the bobbin thread
correctly, otherwise the thread may break
or the thread tension will be incorrect.
Memo
The order that the bobbin thread should be
passed through the bobbin case is indicated
by marks around the bobbin case. Be sure to
thread the machine as indicated.
e Lightly hold down the bobbin with your right
hand, and then guide the thread as shown with
your left hand.
Winding/Installing the Bobbin 27
1