Baby Lock ellure BLR Instruction And Reference Manual page 172

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
APPENDIX
Error Message Probable Cause
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
The start/stop button was pressed while the foot controller was
connected. You tried to use the foot controller for embroidery.
A stitch other than the buttonhole, bar tack or darning stitch was
selected and the start/stop button was pressed while the buttonhole
lever is lowered.
The buttonhole, bar tack or darning stitch was selected and the start/
stop button was pressed while the buttonhole lever is raised.
You tried to set a number of characters that will not fit within the frame.
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to [ON]. You have selected a pattern for which width
control cannot be used.
You pressed the back key or the utility stitch key or the embroidery key
while a pattern was selected.
Bobbin thread has run out.
Little bobbin thread remains.
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
A twin needle was set up with a pattern where a twin needle cannot be
selected.
A pattern is being stored.
The bobbin winder is winding the bobbin.
170