Front Panel Description - Krell Industries Showcase Owner's Reference Manual

Front Panel Description

See Figure 3 on page 11
FEATURES
Basic Operation
Buttons
Input Device Selection
Buttons and LEDs
12
The Showcase Processor front panel provides power on and off;
input, and processing mode selection; monitoring and display of
processor status; and balance and volume control. The front panel
features are described below:
1 Power Button
The power button switches the Showcase Processor from stand-by
to the operational mode.
2 Power LED
The blue power LED illuminates when the Showcase Processor is in
the operational mode.
3 Stand-by LED
The red stand-by LED illuminates when the back panel power switch
(51) is on, indicating that the Showcase Processor is in the stand-by
mode. Krell recommends that the back panel power switch remain
on at all times.
4 Infrared Sensor
The infrared sensor receives commands from the Showcase
Processor remote control. For proper remote control operation, make
sure the infrared sensor is not covered or obstructed.
5 Infrared Emitter
Emits the Showcase Processor remote operation code to a learning
remote. See Program Remote, on page 61.
The Showcase Processor is equipped with ten input device selection
buttons. If properly configured, the Showcase Processor automatically
engages the correct video and audio inputs when you press the
device selection button.
6 DVD Button
Use this button to select the digital videodisc device.
7 LD Button
Use this button to select the laser disc device.
8 SAT Button
Use this button to select the satellite feed device.
Krell Showcase Processor