To Select The Initial Video Signal And Format - Krell Industries Showcase Owner's Reference Manual

Getting Started,
continued
TO SELECT THE INITIAL
VIDEO SIGNAL AND
FORMAT
Krell Showcase Processor
1. Connect your video monitor to the video output connectors on
the Showcase Processor that correspond to the input connectors
on your video monitor. See Table 1, on page 6.
2. Power on the Showcase Processor by switching the back panel
power switch to on. Wait for the Showcase Processor to initialize.
Then press the power button on the front panel.
3. Press the front panel input device selection button that matches
both the video format and video signal compatible with your con-
nected video monitor. See Figure 1 for North American operation
and Figure 2 for International operation. This becomes the cur-
rently selected video signal output.
4. Verify that the video monitor's video signal input corresponds to
the Showcase Processor video signal output. Press the menu
key on the remote control to verify that the OSD is now viewable
on the video monitor. The system configuration main menu
appears when the video format and video signals between the
Showcase Processor and your video monitor are compatible.
If you have any questions regarding the selection of the video format,
please call your authorized Krell dealer, distributor, or Krell.
9