Installer Setup - Honeywell Tradeline T8611M Installation Instructions Manual

INSTALLER SETUP

NOTE: For most applications, the thermostat factory
settings do not need changing. Review the
Factory Setting column in Table 3 and if no
changes are necessary, go to the Installer
System-Test section.
The Installer Setup is used to customize the thermostat
to specific systems. Some of the options include
temperature display, changeover and outdoor
temperature display. Use the Installer Setup numbers
listed in Table 3. The table includes all the configuration
options and the factory-settings for the T8611.
A combination of key presses are required to use the
Installer Setup feature.
1. To enter the Installer Setup, press and hold the
Information i key and the increase
decrease keys until the first number is displayed.
All display segments appear for approximately
three seconds before the number displays.
See Fig. 10 and 11.
2. To advance to the next Installer Setup, press the
Time key.
3. To change a setting, press the increase
decrease key.
4. To scroll the Installer Setup numbers backward,
press the Time
5. To exit the Installer Setup, press Run Program.
Installer
Setup
Number
(Press Time
key to
change)
Select
Not used. 1 thru 4
Number of 3
compressor
stages.
(Not used)
Heating cycle.
6
7
Not used. 8 thru 11
System setting 12
adjustment.
Adaptive 13
Intelligent
Recovery™
control.
Degree 14
temperature
display.
and
key.
Table 3. Thermostat Installer Setup Options.
Factory Setting
Display Description
—
2 Two compressor
stages or two speed
compressor.
— —
6 Auxiliary heat.
9 Emergency heat.
—
1 Manual changeover.
0 Adaptive Intelligent
Recovery™ control is
activated (system
starts early so setpoint
is reached by start of
program period).
0 Temperature is
displayed in F.
DELUXE PROGRAMMABLE HEAT PUMP THERMOSTAT
Wait
Set Program
Recovery
Hold for
Filter
Em Ht
Mon Tue Wed Thu Fri Sat Sun
Wake Leave Return Sleep
Fig. 10. Display of all LCD segments.
Fig. 11. Display of Installer Setup number and setting.
IMPORTANT
Only configurable numbers are shown on the
or
device; for example, if the thermostat does not
have a system key, Installer Setup Number 12 will
not be displayed. Review Table 3 Factory Setting
column and mark any desired changes in the
Actual Setting column. When Installer Setup is
complete, review the settings to confirm they
match the system.
(Press
Display
— —
1
—
3, 6 or 9 6—6 cph used for last stage of
3, 6
or 9
— —
0 or 2
1
1
5
Set Day/Time Temporary Setting
AM
PM
Aux Ht Days
Repl Batt Room
Heat Cool
DST
FACTORY SETTING OR OTHER
INSTALLER SETUP
CHOICE DISPLAY (COLUMN 3
NUMBER DISPLAY
OR 5 OF TABLE 3)
(COLUMN 2 OF TABLE 3)
Other Choices
or key to change)
Description
—
Single stage compressor
systems.
3—3 cph.
heat pump systems.
9—9 cph used for electric
heat.
—
0—Auto changeover.
2—Fixed auto changeover.
Conventional recovery (system
starts recovery at programmed
time).
Temperature is displayed in C.
System
Em Heat
Off
Cool
Auto
Fan
Outdoor
On
Auto
M14559
M14618
Actual
Setting
—
—
—
(Continued)
69-1415