Honeywell
T8600,T8601,T8602,T8611,T8624
Thermostats
FURNACE AIR FILTER, HUMIDIFIER PADAND ULTRAVIOLET(UV) LAMP
TIMERS
The thermostat has up to three timers to help the homeowner remember when to change or clean the furnace air filter,
whole-house
humidifier pad or ultraviolet air treatment system UV lamp. See Table 1.
Timer Measurement
Calendar days in any mode.
Calendar days in Heat mode only.
System run time in any mode.
Table
1. Thermostat
timers.
Type
of Thermostat
Manual
System
Switches
Pusbbutton
System
Keys
(Heat,
Off,
Cool)
(Heat,
Off,
Cool)
Furnace
air filter
and UV lamp
timers
UV lamp timer
Humidifier
pad timer
Humidifier
pad timer
--
Furnace
air filter timer
View or ResetTimer Settings
When the thermostat activates a timer, the thermostat
flashes Filter until the timer resets.
1.
Reset the timer by pressing the i key until the
expired timer is displayed.
u
P!
IP--
Filter
Days
2.
Press the Time Akey to reset the timer.
ZqLI
Pl
!_--
Filter
Days
M2(1244
3.
Press the Run Program key.
NOTE:
You can view the number of days remaining at
any time by pressing the i key three or four
times. If more than one timer is active, ell active
timers show sequentially
when pressing the
i key several times.
For complete instructions on replacing or cleaning your
furnace filter, humidifer pad or UV lamp, see the product
owner's manuals. Contact your local contractor or visit
www.bonewveli.com/vourhome.
For instructions on entering installer Setup mode, see
product installation instructions (installers only). Table 2
gives installer Setup instructions for the timers.
® US. Registered
Trademark
Copyright @ 2002 Honeywell
•
_
*All Rights Reserved
(_9- [ 5 _4-
[