Installer Setup - Honeywell TRADELINE T8011R Product Data

T8011R PROGRAMMABLE HEAT PUMP THERMOSTAT
WALL
MOUNTING
SCREWS (2)
Fig. 3. Mounting wallplate to wall.
Wiring
IMPORTANT
Use an 18-gauge maximum wire for wiring the
T8011R Thermostat.
All wiring must comply with local electrical codes and
ordinances. Disconnect the power supply to prevent electrical
shock or equipment damage.
The shape of the terminals permits insertion of straight or
wraparound wiring connections; either method is acceptable.
A letter code is located near each terminal for identification.
See Fig. 4.
TERMINAL
SCREW
G
C
R
W1
Y
Fig. 4. Wiring connections.
NOTE: To ensure proper mounting of thermostat, restrict all
wiring to the shaded area in the center of the
terminals. See Fig. 5.
68-0196–1
WALL
ANCHORS (2)
WALLPLATE
M12202
FOR STRAIGHT INSERTION
STRIP 5/16 IN. (8 MM)
FOR WRAPAROUND
STRIP 7/16 IN. (11 MM)
L
W2
E
B
O
M11334
KEEP WIRING IN
SHADED AREA
G
C
R
W1
Y
WIRING ENTRANCE
MOUNTING
HOLE
SCREW HOLE
Fig. 5. Restrict wiring to shaded area.
The T8011R Heat Pump Thermostat is powered directly from
the system transformer.
Refer to Fig. 6 for typical wiring hookup.
Mounting Thermostat to Wallplate
1. Slide System switch to the Off position.
2. Engage the tabs at the top of the thermostat and
wallplate.
3. Swing down the thermostat and press the lower edge of
the thermostat onto the wallplate to latch. See Fig.7.

INSTALLER SETUP

° °
Setting F/ C Indication and Heat Cycle Rate
The following instructions provide the information necessary
to change the heating cycle rate to match the heating
equipment and to choose either Fahrenheit (°F) or Celsius
(°C) display.
NOTE: All four steps must be completed to save changes to
the °F/°C indication and the heat cycle rate.
4
L
W2
E
B
O
MOUNTING
SCREW HOLE
M11331