Table of Contents
Advertisement
Before you can directly call a PARTNER phone system from a remote location, you must
assign the outside line that you have dedicated to your PARTNER modem to a Hunt Group.
This will enable an outside call to bypass the receptionist and ring directly at
the PARTNER modem.
Assign the outside line to a Hunt Group.
1 From extension 10 or 11, activate System Programming by pressing
,
Feature
0
0
2 At the GROUP: prompt, enter a group number (1-6)
We recommend the number 6.
3 At the Line prompt, enter the line number that you will be dedicating to use for
remote access.
Now you must program the Hunt Group to ring at the modem.
4 Press
#
5
0
5
5 At the GROUP: prompt, enter the number you entered in Step 2. A display similar
to the following appears:
HUNT GROUP #
EXTENSION:
6 Enter
7
6
(This is the pre-established extension number for your PARTNER modem.)
7 Press
Feature
0
Now you must change the ringing options so this dedicated line does not
ring at all your phone extensions.
8 From extension 10 or 11, activate Centralized Programming by pressing
,
Feature
0
0
9 Enter an extension number
The green lights next to the line buttons show the current Line Ringing settings:
Immediate Ring - steady light; Delayed Ring - slow flash; No Ring - quick flutter
10 Press the line button until the button light is set to No Ring (quick flutter)
11 Repeat Steps 9 and 10 for all extensions, except 76
12 Press
Feature
0
For information about the location of special programming buttons on a PARTNER
phone, see the PARTNER system documentation.
,
System Program
System Program
to exit programming
0
,
System Program
System Program
to exit programming
0
#
2
Central Tel Program
C o n n e c t i n g t o t h e PA R T N E R A C S S y s t e m
0
6
15
3
Advertisement
Table of Contents
