Outside Auto Dial; Special Characters In Outside Auto Dial - AT&T MERLIN 3070 Attendant's Manual

OUTSIDE AUTO DIAL

To program: T/P to P Touch the button Dial
side number
For one-touch dialing, program Outside Auto Dial buttons with frequent-
ly dialed outside numbers or account numbers.
Without lifting your handset, touch an Outside Auto Dial button.
Your voice terminal speaker goes on, and you hear a dial tone, then dialing
signals.
Lift your handset when you hear the other person answer.
If the line is busy or if no one answers:
Touch Speaker to cancel the call.

Special Characters in Outside Auto Dial

When you program your console with Outside Auto Dial numbers, you may
need to program special characters into the dialing sequence. For exam-
ple, if you program the access code for an alternate long distance ser-
vice, you might need to program a telephone number, a pause, Touch-
Tone Enable, another pause, and an access code into one sequence.
Below are the characters you can use.
Pause. To program a pause (1.5 seconds) into a dialing sequence (for
example, between a pool access code and a telephone number in an Out-
side Auto Dial sequence):
Touch Hold (Pause).
Touch-Tone Enable. To program Touch-Tone Enable into a dialing se-
quence (for example, before a credit card authorization code):
Touch Transfer.
Switchhook Flash. To program a switchhook flash (for example, in a
PBX, Centrex, or Custom Calling feature code):
Touch Recall.
Touch Hold (Pause).
Stop. To program a stop into a dialing sequence (for example, a com-
puterized banking service):
Touch Drop (Stop).
To use Outside Auto Dial sequences with a stop in them:
Touch the Outside Auto Dial button.
Wait until the connection is made after the stop.
Touch the button again to resume dialing.
+ the out-
*90
T/P to center
3 7