Table of Contents
Advertisement
Primary/Secondary IDE 1/0 (Disabled)
When these items are enabled, the system will restart the power-saving timeout counters
when any activity is detected on any of the drives or devices on the primary or secondary
IDE channels.
FDD, COM, LPT Port (Disabled)
When this item is enabled, the system will restart the power-saving timeout counters when
any activity is detected on the floppy disk drive, serial ports, or the parallel port.
PCI PIRQ[A-D]# (Disabled)
When this item is enabled, any activity from one of the listed devices wakes up the system.
PNP/PCI Configurations
These options configure how PnP (Plug and Play) and PCI expansion cards operate in your
system. Both the ISA and PCI buses on the Motherboard use system IRQs (Interrupt
ReQuests) and DMAs (Direct Memory Access). You must set up the IRQ and DMA assign-
ments correctly through the PnP/PCI Configurations Setup utility for the motherboard to
work properly. Selecting PnP/PCI Configurations on the main program screen displays this
menu:
Reset Configuration Data
Resources Controlled by
x
IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For USB
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin3 Assignment
INT Pin4 Assignment
INT Pin5 Assignment
INT Pin6 Assignment
INT Pin7 Assignment
INT Pin8 Assignment
: Move
F5:Previous Values
Reset Configuration Data (Disabled)
If you enable this item and restart the system, any Plug and Play configuration data stored
in the BIOS Setup is cleared from memory.
Resources Controlled By (Auto(ESCD))
You should leave this item at the default Auto. Under this setting, the system dynamically
allocates resources to Plug and Play devices as they are required. If you select the
"Manual" option, the prompt on the following line, "IRQ Resources" will become available
to you.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion card to work
properly, you might be able to solve the problem by changing this item to Manual, and
then opening up the IRQ Resources submenu.
Phoenix-AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
Enter: Select
+/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F6:Fail-Safe Defaults
New updated data is created.
Using BIOS
[Disabled]
Item Help
[Auto(ESCD)]
Press Enter
Menu Level
[Disabled]
Default is Disabled. Select
[Enabled]
Enabled to reset Extended
[Auto]
System Configuration Data
[Auto]
ESCD) when you exit Setup
[Auto]
if you have installed a new
[Auto]
add-on and the system
[Auto]
reconfiguration has caused
[Auto]
such a serious conflict that
[Auto]
the OS cannot boot
[Auto]
F7:Optimized Defaults
43
Advertisement
Table of Contents
