Table of Contents
Advertisement
Installing Memory Modules
This motherboard accommodates four memory modules. It can support four184-pin 2.5V
unbuffered DIMM. The total memory capacity is 4GB.
DDR SDRAM memory module table
You must install at least one module in any of the four slots. Each module can be installed
with 256 MB to 1 GB of memory; total memory capacity is 4GB.
Do not remove any memory module from its antistatic packaging until you
are ready to install it on the motherboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear a
grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1
This motherboard supports unbuffered DDR SDRAM only.
2
Push the latches on each side of the DIMM slot down.
3
Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4
Check that the cutouts on the DIMM module edge connector match the notches
in the DIMM slot.
5
Install the DIMM module into the slot and press it firmly down until it seats
correctly. The slot latches are levered upwards and latch on to the edges of
the DIMM.
6
Install any remaining DIMM modules.
Memory module
DDR 266
DDR 333
DDR 400
Installing the Motherboard
Memory Bus
133MHz
166MHz
200MHz
15
Advertisement
Table of Contents
