Drawing A Fan Shape - Brother PE-Design 6.0 Instruction Manual

PeDesignV6Eng.book Page 146 Thursday, July 8, 2004 11:59 AM
Layout & Editing
→ A radial line appears on the oval when the
mouse button is released.
4.
Move the pointer to the start point of the arc,
and then click.
→ The radial line disappears.
5.
Move the pointer until the arc has the desired
shape, and then click.
Click at start point.
Move to end point.

Drawing a fan shape

1.
Click on the Tool Box.
→ The shape of the pointer changes to
, and the Sewing Attributes bar ap-
pears similar to the one shown below.
b
Memo:
• You can change the color and sew type
either before or after drawing the shape.
For more details on changing these
settings, refer to "Color" on page 169 and
"Sew type" on page 170.
• You can also use the settings in the
Sewing Attribute Setting dialog box to
define other attributes of the shape. (For
more details, refer to "Specifying sewing
attributes" on page 171.) If you do not
change these settings at this time, the
current settings will be applied, however
you can modify them later.
146
2.
3.
4.
5.
Click at end point.
Editing Embroidery Patterns
Click in the Arc shape selector, and then click
Fan Shape.
Proceed as you would to draw a circle or an
oval.
→ A radial line appears on the oval when the
mouse button is released.
Move the pointer to the start point of the fan
shape, and then click.
→ The radial line disappears.
Move the pointer until the fan has the desired
shape, and then click.
Click at start point.
Move to end point.
Click at end point.