Brother PE-Design 6.0 Instruction Manual page 102

PeDesignV6Eng.book Page 94 Thursday, July 8, 2004 11:59 AM
Design Center
Width (horizontal length)
Height (vertical length)
Direction
Offset
Programma-
ble fill
Base
Sew
Specifies
the base
stitching.
(For details,
refer to the
illustration
below.)
Pattern
94
Select a pattern for programmable fill stitch.
Click , and then, in the Browse dialog box that appeared, select the folder
containing the .pas file that you want to use. Double-click the desired pattern, or
select it, and then click OK.
Sets the stitch pattern width.
Range: 2–10 mm (0.20–0.39 inch)
Default: 7.5 mm (0.30 inch)
Sets the stitch pattern height.
Range: 5–10 mm (0.20–0.39 inch)
Default: 7.5 mm (0.30 inch)
Allows you to rotate the angle of the stitch patterns.
Range: 0–359 degrees
Default: 0 degrees
Sets the direction of the offset as row/column.
Direction
When the pattern's arrangement is offset, sets the amount of offset.
Value Range: 0–99%
Default: 0%
Specifies the shape of stitching on the edges.
Available only when the Base Sew check box is
selected.
Stitch
Type
Available settings:
Default:
Sets the pitch of the stitching for the base of a programmable fill stitch.
Available only when the Base Sew check box is
selected.
Step Pitch
Range: 1–10 mm (0.04–0.39 inch)
Default: 4.0 mm (0.16 inch)
Sets the spacial frequency steps of the stitching for the base of a programmable
fill stitch.
Available only when the Base Sew check box is
Frequency
selected.
Range: 0–99%
Default: 30%
Stage 4 (Sew Setting Stage)
,
The stitching for the base (area
other than the pattern indicated
by the diagonal lines) of the pro-
grammable fill stitch can be set.
The pattern is sewn with the
specified stitching.
90°
135° 45°
180°
0°
225°
315°
270°
row
column
Step pitch
0%
30%