Brother PE-Design 6.0 Instruction Manual page 133

PeDesignV6Eng.book Page 125 Thursday, July 8, 2004 11:59 AM
Layout & Editing
5.
In the Gray Balance dialog box, click Next.
→ The Photo Stitch 2 Parameters dialog
box appears.
6.
Specify the settings for creating the
embroidery pattern.
b
Memo:
• To return to the previous dialog box, click
Previous.
• To quit the operation and close the dialog
box, click Cancel.
Sewing Option
Specifies the interval between parallel
lines used to create the embroidery
pattern.
Range: 1.2 to 5 mm (0.05 to 0.2 inch)
Line Interval
Default: 2 mm (0.08 inch)
Specifies the maximum density for
areas of the created embroidery pattern
sewn with the zigzag stitch. The
embroidery pattern will be created with
Max. Density a density smaller than that set here.
Range: 2.5 to 5 lines per mm (64 to 127
lines per inch)
Default: 3 lines per mm (76 lines per
inch)
Use Color
Specifies the color of thread used to create the
embroidery pattern.
The default setting is the darkest color in the
current thread chart.
Click this button to open the Thread
Change Color dialog box, which lets you select
Color the thread color used in the embroidery
pattern.
Inputting Images and Embroidery Patterns
7.
In the Photo Stitch 2 Parameters dialog box,
click Next.
→ A Preview dialog box similar to the one
shown below appears, allowing the creat-
ed embroidery pattern to be previewed.
b
• To return to the previous dialog box, click
Previous.
• To quit the operation and close the dialog
box, click Cancel.
8.
Click Finish.
→ An embroidery pattern is created and dis-
played in the Design Page.
■
If Cross Stitch is selected
→ The Cross Stitch Attributes dialog box
Line interval
appears.
1.
Specify the settings for creating the
embroidery pattern.
b
• To return to the previous dialog box, click
Previous.
• To quit the operation and close the dialog
box, click Cancel.
Memo:
Memo:
125