Disabling Power To The Crs-1 Fabric Card - Cisco CRS-1 - Carrier Routing System Router Migration Manual

How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
Command or Action
Step 5
commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Step 6
end
Example:
RP/0/RP1/CPU0:router(admin-config)# end
Step 7 Repeat Step 3 through Step 6 for each fabric plane.
Step 8
show controllers fabric plane all
Example:
RP/0/RP1/CPU0:router(admin)# show controllers
fabric plane all
What to Do Next
Next we disable power to the Fabric node, and verify that node is moved to Unpowered state.

Disabling Power to the CRS-1 Fabric Card

Prerequisites
Software Requirements
•
•
•
Caution The ROM Monitor software must be upgraded to version 1.54 or a later version on all RPs and/or
upgraded to version 1.52 or a later version on all DRPs before a Cisco CRS-1 system is upgraded to
Cisco IOS XR Software Release 4.0.0.T or later release. If the router is brought up with an incompatible
version of the ROM Monitor software, then the standby RP may fail to boot. For instructions to overcome
a boot block in the standby RP in a single chassis system, see Cisco IOS XR ROM Monitor Guide. For
other issues, contact your Cisco Systems support representative for assistance. See
Documentation, Obtaining Support, and Security Guidelines, page
For more information, see Cisco IOS XR ROM Monitor Guide.
Hardware Requirements
•
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-42
Cisco IOS XR Software Release 4.0.0.T or later release (Cisco IOS XR Software Release 4.0.2 for
multishelf nodes)
ROMMON 1.54 or later version (for Route Processor [RP])
ROMMON 1.52 or later version (for Dual Route Processor [DRP])
The system hardware should be prepared as described in the
Cisco CRS-3 Carrier Routing System" section on page
Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System
Purpose
Commits the target configuration to the router running
configuration.
• This step brings up the previously shutdown plane,
which is now configured to use the FCC-CRS-3 fabric
card.
Changes the mode from administration configuration mode
to administration EXEC mode.
Displays the administrative and operational status of all
eight fabric planes.
Verify that all fabric planes are administrative state
•
down.
v.
"Prerequisites for Upgrading to a
1-2.
Obtaining
OL-13669-03