Cisco CRS-1 - Carrier Routing System Router Migration Manual page 218

show controllers (Ethernet)
MTU: Not configured
Soft Bandwidth: Not configured
Driver constraints:
Min MTU: 64 bytes
Max MTU: 9216 bytes
Max speed: 10Gbps
Interface type: TenGigE
Management interface: No
Promiscuous mode: Yes
Allowed config mask: 0x27b
Cached driver state:
MTU: 1522 bytes
Burnt-in MAC address: 001d.353b.975e
Bundle settings:
Aggregated: No
Bundle MTU: 1514 bytes
Bundle MAC address: 001d.353b.975e
Port FSM state:
Port is disabled, due to an admin down condition.
Complete FSM state:
Admin down
Bundle admin up
Client admin up
Client admin tx not disabled
Port disabled
Port tx disabled
Hardware link down
IDB interface state information:
IDB bundle admin up
IDB client admin up
IDB client tx admin up
IDB error disable not set
0 Unicast MAC Addresses:
0 Multicast MAC Addresses:
0 Unicast Bundle MAC Addresses:
0 Multicast Bundle MAC Addresses:
The following example shows sample output for the show controllers TenGigE control command for
the Cisco CRS 14-Port 10-Gigabit Ethernet LAN/WAN-PHY Interface Module:
RP/0/RP0/CPU0:Router# show controllers TenGigE 0/1/0/0 control
Thu Oct
Management information for interface TenGigE0/1/0/0:
Port number: 0
Bay number: 0
Interface handle: 0x1180200
Config:
Auto-negotiation: Configuration not supported (Off)
Carrier delay (up): Not configured
Carrier delay (down): Not configured
Speed: Configuration not supported (10Gbps)
Duplex: Configuration not supported (Full Duplex)
Flow Control: Not configured (None)
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-58
7 18:26:11.815 EST
Chapter 3 Cisco CRS-3 Carrier Routing System Router Command Changes
OL-13669-03